FN SCAR 16S 5.56x45mm FDE 16-in 30-Rnd

(1 review) Write a Review
7.25 LBS

or Register for Member Pricing

Request Quote, Quantity Discounts, or purchasing more than current stock. Use the Request Quote Button.

Out Of Stock

Frequently bought together:


The FN SCAR is the semi-auto only version of the newest service rifle of U.S. special operators. Light, fast-handling and quick shooting, the FN SCAR® 16S is chambered in 5.56×45 mm and features a free-floating, cold hammer-forged MIL-SPEC barrel with chrome-lined bore. Fully-ambidextrous operating controls instantly adapt to any shooter and any shooting position. The receiver-integrated MIL-STD 1913 optical rail and three accessory rails enable the mounting of scopes or electronic sights, plus tactical lights and lasers. The telescoping, side-folding polymer stock is fully adjustable for comb height and length of pull, and is available in Flat Dark Earth (FDE) or matte black.

Since its adoption of the AR15 by the U.S. Air Force in 1962, and by the U.S. Army in 1964, the basic individual military weapon of the United States has demonstrated certain compromises inherent in its design and cycle of operation.

Foremost among these compromises is the direct-gas impingement operation system. During the firing and ejection cycles, substantial amounts of carbon and other by-products of cartridge combustion are routed directly into the bolt and receiver areas, causing increased fouling. Naturally, this increased fouling results in reduced operating reliability and requires greater frequency of cleaning and other maintenance by the weapon operator.

Responding to concerns from special operators in combat regarding the reliability, accuracy, safety and ergonomics of the current platform, the Naval Surface Warfare Center, Crane, began an investigation of potential improvements. In the years that followed the U.S. Government conducted an Analysis of Alternatives (AoA) to determine if enhancements or upgrades could be made to the existing platform, or if a new weapon was needed. It was determined that a new, more reliable and more adaptable individual weapon was required.

In late 2003, the Joint Operational Requirements Document for a new combat assault rifle was approved and signed; the following January, a worldwide solicitation was issued to the military firearms industry.

In July 2004, in a full and open competition, nine vendors submitted twelve different designs for the three new weapon systems. Unlike the competition, FN delivered a new weapon built to the operator’s requirements—not adapted to them. The FN SCAR® submission passed all of the GO/NO-GO criteria and was unanimously chosen by the selection board composed of senior SOF operators representing every selection component. In November of the same year, FN was awarded the full FN SCAR® contract for both 5.56mm and 7.62mm rifles, along with the 40mm Enhanced Grenade Launcher Module (EGLM).

Developmental testing by FN designers, engineers and operators from various branches of the U.S. Military to evaluate the new weapons’ endurance, reliability and accuracy was conducted from August 2005 through January 2006. Four Early User Assessments were also conducted prior to, during and after the developmental testing process to integrate operator feedback into the final FN SCAR® design.

FN SCAR Principle of Operation


The MK 16 and MK 17 rifles operate on the short-stroke gas piston system. As the bullet passes the gas port in the barrel a portion of the propellant gases are routed through the gas regulator to the gas piston located below the front sight post. The gas pushes rearward against the piston, which drives the moving parts assembly rearward to eject the fired case and load a new cartridge from the magazine. Excess gases are vented forward through the gas vent hole in the front of the gas regulator. The advantage over the direct gas impingement system is that heat, soot and carbon from propellant combustion are not routed into the bolt or chamber, keeping these critical areas cooler and cleaner for greater reliability and enhanced accuracy. When compared to a direct gas impingement system that has been adapted to use a gas piston or operating rod, the FN SCAR® gas system proves to be more simple, robust and reliable. The first position on the gas regulator is for normal operation, while the second position ensures there is no increase in the cyclic rate of fire when using a sound suppressor.

Low-Rate Initial Production (LRIP) and Production

Acceptance Test and Evaluations were conducted from May 2006 through June of 2007. Beginning in August 2007, the Initial Operational Test and Evaluation phase was conducted by various units of the U.S. Military community, including the U.S. Army Rangers, U.S. Marine Corps Special Operations Command, U.S. Navy SEALS and U.S. Army Special Forces. These tests were carried out in a variety of operational environments including urban, maritime, jungle and winter/mountain warfare situations.

Final testing was completed in September of 2008 and the FN SCAR® and EGLM were announced as Operationally Effective/Operationally Suitable and Sustainable (OE/ OS). Initial fielding to operational units with U.S. special operators began in April 2009. The first operational units armed with the FN SCAR® system deployed for overseas duty in the summer of 2009.

In April 2010, upon successful in-theater combat assessments, the FN SCAR®(MK 16 and MK 17) and the EGLM (MK 13) were granted Milestone C (the acquisition phase associated with fielding/deployment). In August of the same year the FN SCAR® system received approval for full-rate production for the MK 16, MK 17 and MK 13.



  • CALIBER: 5.56x45mm
  • OPERATION: Short-stroke gas piston
  • MAG CAPACITY: 10 or 30 Rd.
  • WEIGHT: 7.25 lb.
  • BARREL LENGTH: 16.25"
  • OVERALL LENGTH: 27.5" - 37.5"


Semi-auto only

Short-stroke gas piston

Rotating, locking bolt



Hard-anodized monolithic aluminum

MIL-STD 1913 accessory rails at the 3, 6, 9 and 12 o’clock positions

Adjustable folding front and folding/removable rear iron sights



Hammer-forged, chrome-lined, fully free-floating




Telescoping side-folding polymer stock

Adjustable cheekpiece

A2-style pistol grip



Ambidextrous safety lever and magazine release

Charging handle may be mounted on right or left side

Enlarged trigger guard for easier access when wearing gloves

Composite polymer trigger module



Steel or aluminum body

Low friction follower



WARNING This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. (California law requires this warning to be given to customers in the State of California.)

View AllClose

Additional Information

Product ID:
View AllClose

1 Review

  • 5

    Posted by Scott K. on 18th Sep 2013

    These barrels could not have been released at a better time since I just got my SCAR 16 Form 1 back. BOTACH had the best prices on these barrels with free shipping. Excellent product and great service from BOTACH. -Scott

View AllClose